Strut Tower Brace http://razorsedgemotorsports.com/raeddochstto.html This braces features the benefit of super tough 4130N Chrome-moly alloy steel. This makes them more than twice as strong without adding any additional weight. If you're looking for true race car performance and the best strength-to-weight ratio this is the part for you! Benefits: * Made from 4130 Chrome Moly Steel * Each piece is percision welded * Closed triangle shape for strength and ultimate handling * Improved Steering response * No need to cut the underhood liner
As far as functionally...that one looks like it would be SO much better for chargers than the DC Sports one (that i have)...no more cutting or adjusting or anything...just install and drive!...ascetically though i like my DC
Nice find. Until I figure out a nice clean way to install my DC Strut Tower brace or at least cover up the hacking in a way that's cool...I won't be installing it. I may even have it for sale if it takes too long.
take off your engine cover...cut it up nicely using an outline and some tape...then put some rubber stripping over it so it looks neat...call it a day haha
Scott, did you ever answer my question on how much the rear will cost? If not....how much does it cost? lol
You will need to trim your rear panels atad..Other then that no modifications will be needed..Oh Thats not my car.That was a rent a wreck that was used for some of the final touches..I couldn't make it that day..lol
Be also looking for the under body braces too. Full posts are here... http://www.lxforums.com/board/forumdisplay.php?f=278
I'm not really sure which type, or vendor, of forced induction I'll be buying...but I will be buying one...and a 426. But, I will be swapping out my DC STB for a Razors Edge front one...and the under body braces!
