polished intake

[Howdee]

I'm in the procees of polising my 6.1 intake (what a job!) .Those who have one, what intake bolts did you go back with? Stainless steel would look better but I'm not sure about the grade, any advise?

 

[Ronin]

I'm in the process of polishing my 6.1 intake (what a job!) .Those who have one, what intake bolts did you go back with? Stainless steel would look better but I'm not sure about the grade, any advise?

I'm sorry...what was that...question...huh? Avatar...azz...can't think straight. Sorry, I don't have an answer to your question, but have one for you instead...

You don't have a full/wallpaper size photo of that avatar, do ya? Thanks!

Matty

 

[Howdee]

I'm sorry...what was that...question...huh? Avatar...azz...can't think straight. Sorry, I don't have an answer to your question, but have one for you instead...

You don't have a full/wallpaper size photo of that avatar, do ya? Thanks!

Matty

Matty, I'll look to see where and get back to ya.
As I recall, full size you can even see a few critters scurring to a fro the nest, if you look real close, that is! I always like printing this one so I can sniff the fresh ink:whistle:

 

[1bad4dr]

using the factory bolts on mine...