Pinning the crank........

Discussion in 'Engine & Performance Modifications' started by Hemi31, Jun 4, 2008.

Page 2 of 2
  1. Jun 11, 2008 at 4:29 PM #21
    Quick

    Quick Mgmt. - I can't help you

    Messages:
    7,549
    Likes Received:
    0
    Joined:
    Nov 6, 2007
    Location:
    San Jose, CA
    Is that all tempered steel? did you drill slowly with a lot of oil?
     
  2. Jun 11, 2008 at 4:36 PM #22
    1bad4dr

    1bad4dr Mr. Meany

    Messages:
    19,670
    Likes Received:
    0
    Joined:
    Oct 10, 2007
    Location:
    Corn Country
    Mine is keyed...
     
  3. Jun 11, 2008 at 4:43 PM #23
    Hemi31

    Hemi31 [email protected]

    Messages:
    1,731
    Likes Received:
    0
    Joined:
    Nov 7, 2007
    Location:
    AuSable Forks, NY
    No oil.......bit is made to run dry.Crank is all Forged steel.What a PITA......but it's better than destroying the crank with a pulley that won't hold.
     
  4. Jun 11, 2008 at 5:07 PM #24
    1fastsedan

    1fastsedan Destroyer of Warranties

    Messages:
    1,933
    Likes Received:
    0
    Joined:
    Nov 6, 2007
    Erik, do you have a link to the jig you used (if any). That looks like a serious cut you made.
     
  5. Jun 11, 2008 at 5:17 PM #25
    Hemi31

    Hemi31 [email protected]

    Messages:
    1,731
    Likes Received:
    0
    Joined:
    Nov 7, 2007
    Location:
    AuSable Forks, NY
    I didn't buy the Jig Scott.
     
Page 2 of 2