Dyno Sheet/426 Mondello Stage2 Heads

Discussion in 'Stanko Performance Products' started by sgtstanko, Jan 9, 2009.

  1. sgtstanko

    sgtstanko Want to go FASTER!!!

    Messages:
    1,395
    Likes Received:
    0
    Joined:
    Nov 7, 2007
    I FINALLY found a friendly shop with an in ground AWD dyno. The shop is called Intergrated Performance and they have a Dynamic Dyno AWD dyno with adjustable front to rear rollers to accomodate larger vehicles. It is so refreshing to have the beast sitting down in four (4) rollers versus bouncing around on front and rear single rollers like a DynoJet model. The DTS doesnt throw the big numbers a Dyno jet provides, but close enough for checking my preliminary tune from Bob@SVS. Needless to say I was pleased by the back to back consistent results!

    They did three pulls, first one was a test, pulls 2 and 3 (shown below) were good enough for me. The test was with conducted with 91 octane unleaded fuel at 188-190 degrees coolant temp. This also gives me a good baseline before the "WetFlow" Mondello Stage 2 heads go on Saturday 1/10/2009.


    [​IMG]


    [​IMG]


    .
     
    Last edited: Jan 10, 2009
  2. MOL

    MOL SHOW & PERFORMANCE

    Messages:
    1,844
    Likes Received:
    0
    Joined:
    Nov 7, 2007
    Location:
    SAN DIEGO, CA
    i like what i see there.
     
  3. sgtstanko

    sgtstanko Want to go FASTER!!!

    Messages:
    1,395
    Likes Received:
    0
    Joined:
    Nov 7, 2007

    Thanks MOL......I like the flat torque curve.



    .
     
  4. SOUTHERNHOTROD

    SOUTHERNHOTROD Supporting Vendor

    Messages:
    380
    Likes Received:
    0
    Joined:
    Nov 13, 2007
    Location:
    www.SOUTHERNHOTROD.com
    Steve,

    What cam do you have in that thing?
     
  5. sgtstanko

    sgtstanko Want to go FASTER!!!

    Messages:
    1,395
    Likes Received:
    0
    Joined:
    Nov 7, 2007

    HHP Stage 3

    .