I was going to bring up this point as well. A 1.51 rod length to stroke ratio isn't the best especially with these new Gen Hemi's.
Right now the int/exh flow numbers are within a few cfm of of a cnc ported 6.1 that we tested these new 5.7 heads against. However the port...
Also Sharadon Performance :bye:
We just finished up with a set of prototye 5.7 cnc heads with 2.10" int/1.60" exh valves. The intake is flowing up to par as we figured, but the...
Chad, You the man. Run fast, run safe. Have you figured out how your going to run your restraint harness yet?
Welcome on board.
We've been in this sort of predicament before with the RFE545 transmissions. We had to deal with the 03's that have a totally different pcm/tcm...
Starting this week, Denny and I are going to start the R&D on the NAG transmissions. Pieces and part's are on the way. I'll get Denny to post up...
We'll be sponsoring the Gen III Hemi class again this year. Time to start planning for this GREAT event.
I'm learning alot about these transmission's lately. I just have to figure out how to put all the pieces of the puzzle together and still make...
Sleeving takes away from the integrity of a block and your only asking for future problems.
sharadon.com We're also listed in the sponsor section.
Welcome to the 11 second club.
We have some mighty fine heads as well.
I need some AFCO Racing rear coil overs for my truck. Hook me up......Please!
Chad, you had the same shifting issues?
We're hoping to help out the LX platform with their tranny problems, the same as what we did for the Hemi truck platform. 7 of the 10 fastest...
Building a performance NAG transmission was brought up to the table awhile back, but no one seemed to have any problems with them. Even the guy's...
After Denny got home from church, we had a good conversation. JMatt, up for a little tranny R&D? We'd like the opportunity to help you out with...
We decided to look into the NAG transmissions a while back, but there seemed to be very few failures, if at all, and no one racing them seemed to...
Separate names with a comma.
