Maybe this is why my trunk release does not work??

The trunk release button on my dash does not work. The key fob will open the trunk though.

I was looking in my trunk last night and thought I should straighten up the wad of wires the former owner left around the tire pump. I then notice a wire I had not seen before. It has a plug on the end and comes from under the trunk liner. Could this be the reason my button does not work.

I looked around the trunk for a place to plug it in but did not see anything. Thought I might check here before I start removing panels and have to replace fastners.

Anyone know where this goes and what it does?












.

 

Do you have the factory sub on that side? Looks like the plug for it to me...My car isn't here with me (at work) bu I don't recall anything electrical that went through the foam insert like yours is. I'll try and remember to look in my trunk when I get home.

 

Thanks Kyle...someone else also said it looked like the subwoofer plug...since I bought it used I dont know if it might have originally had the subwoofer.....

 

Go here:

http://www.dodge.com/wccsapp/univer...orms/us/webform.jsp&promotion=null&category=U

and request your build sheet. It will say on there if your SRT had it or not.

 

Thanks for reminding me....My dealer printed one for me...now where did I put that?...

 

That's a bonus part

 

Heck...it is a used car...maybe the previous owner used it for a time machine and that is where the flux thingy plugged in...:hypno:

 

Might have been the connector for that 300 shot he was firing off 2 or 3 times a night...