Paging Talon's transmission :)

Ken, DD just released a new public version. I believe you should be able to see your Transmission Fluid Temperature now.

 

DD= dash daq?

 

Yes. (DashDAQ to be precise )

 

Mine works sometimes.....have to try new version.
With the previous version sometimes it was visible and sometimes not.

Thanks for the tip Dave.

..

 

hmmm, works sometimes? In previous versions that signal wasn't in the list available for selection. Now it should be. I've never seen it not work. This is the one in the Chrysler Specific signals.

 

Oh...
I just noticed you are talking about DashDaq and not DasHawk.

Crap...
Ken has a DashDaq also.

I'm jealous.

..

 

Thanks Dave for the info. I'll be adding the new update today.

Ken

 

Ken, I think it just got posted this afternoon. Version 2.1.2

You might want to go into settings and save your config to the SD card. Don't know if you lose the config when you update. If so, you should be able to update, find signals, then load your saved config from the SD card (I think).

 

Thanks again Dave for the info. :thumb2: Today I was able to down load the new version, and mount the DashDAQ to my "A" pillar pod mount.







Ken

 

Nice Ken. I think I'm going to upgrade to the XL.

They forgot to put a display name on the Trans Fluid Temp signal so it just displays (*F) on the gauge... (have to complain about that). If you wanted you could run that signal through a Rescale Signal (multiplier = 1 and offset =0). With those settings the rescale signal wouldn't do anything to it but it but the Rescale signal let's you name it. Then it would display whatever you put in there like "TransFl" or something.