/ Register

Search Results

Search Again
  1. CNC Tony
    Post

    How to change the gear ratio?

    So far I only found Allusa or something like that, $1300 for the unit :( I was hoping that rear end and converter would be around 1300 total,...
    Post by: CNC Tony, Jul 12, 2010 in forum: How-To/Tech Database
  2. CNC Tony
    Post

    How to change the gear ratio?

    BUMP to top. Anybody?
    Post by: CNC Tony, Jul 10, 2010 in forum: How-To/Tech Database
  3. CNC Tony
    Thread

    How to change the gear ratio?

    I made LOTS of phone calls to dealerships, mechanics, etc. and they all say it can't be done. I want to change my rear end ratio to 3:55 or...
    Thread by: CNC Tony, Jul 2, 2010, 7 replies, in forum: How-To/Tech Database
  4. CNC Tony
    Post

    Advise the noob on heads and cam please

    Custom tune will be done IMMEDIATELY after the install. I talked to a few guys about porting my heads, they all talked a decent game but none...
    Post by: CNC Tony, Jun 26, 2010 in forum: General Discussion
  5. CNC Tony
    Thread

    Advise the noob on heads and cam please

    I have a 2007 300 SRT8 with 30K on the odometer. I want to do heads, cam, springs and timing. Only I need some advice please. I did a lot of...
    Thread by: CNC Tony, Jun 24, 2010, 7 replies, in forum: General Discussion
  6. CNC Tony
    Post

    Newb from Charlotte NC

    Thanks guys. I did the wheels, tails, trunk myself. I purchased a salvage title. The car got into a fight with a hydrant, ripped the door skins...
    Post by: CNC Tony, Jun 24, 2010 in forum: New Member Introductions
  7. CNC Tony
    Thread

    Newb from Charlotte NC

    Hi my name is Tony, I'm from Charlotte NC. I just got a 2007 300 SRT8 with 30K on the odometer. Stock other then a 180Tstat and predator....
    Thread by: CNC Tony, Jun 23, 2010, 12 replies, in forum: New Member Introductions
Showing results 1 to 7 of 7
Search Again