Your welcome........ LOL
True Dat!! The other thing is all off our engine components are relatively new and some problems will occur from time to time... Hope fully...
The one in the pic is stock John, The chamfered gear is around 3/16 Not all K1 cranks have this issue, Check it when building the engine if...
I'm going....
Thanks to a two faced governor and a very biased Liberal state Legislature that's been in office for way to long.... LOL Kaliforniea needs money...
Sometimes if you take it to a different Mech and have them give it a once over. There unbiased eye can find the problem??? Just a suggestion...
This car is Quick, I rarely talk about but Dynos. This 300 is an exception to the rules. Carlos!!! Giddy! Up!! As far as the ARP Wheel Studs,...
Cam you have come up with some really nice looking Mods ..... Dual intake, drive shaft loop anything else??
We just finished up Carlos, I don't know what she felt like before but I'm Jealous as hell..... Also it looks like Bob Nailed the idle and Part...
Come on out Tony....
One thing I have always believed is products are only as good as the service after you've spent your money. With high performance after market...
Sorry Paulie, The first test ride is mine...... LOL The welds on these particular set of exhaust manifolds were smaller then I have ever seen....
Dang the kid is loaded... Here's some pics...
This is what the Jeeps have needed for sometime now.....
Ya those heads seem to have the grin effect.......
I have installed a lot of new gen Hemi Heads over the past couple years....... The first time I laid eyes on the Stanko/Mondello heads I knew they...
A few mustangs and sunday an older 5.0 worked he was actually cool gave me the thumbs up after he finally caught up Ya Rustangs are fun to pick...
Any Killz since the install Tony? You are going to Love that set up!!
Very Very Impressive boys, Leave it up to KB to upset the (Force!!) LOL
Separate names with a comma.
