Separate names with a comma.
New Box Made Well, since the factory box was getting a little annoying real quick with how much room it takes up and that it wouldn’t fit with...
Well, it's kind of hard to explain. You would probably have to take the same corner in a MSRT8 with the brace, and w/o the brace to really notice...
Thanks for the thumbs up everyone! I like the MTX, but I will wait a while before spending the $250 on the box. It will look a lot cleaner once...
It happens a lot – people buy a used Magnum Kicker Sub with no stock wire harness. I spoke with the OEM rep, Jacob, at Kicker and he said that...
The Kicker Sub does not fit with the RE Rear Strut Brace. For me, I just decided to re-position the box and secure it to the brace. A local...
I keep my front plate under the floor mat behind the driver seat just incase. I have thought about using some 3M double sided tape (the kind used...
Yeah, I hear! 390 vs. 400, not much you can notice. Thanks for all the info Jeff!
I talked to Bob when I was there and mentioned that I thought it would've been higher. I just turned 9,000 miles on my way back from Sac -...
I am not sure if he did a "full" CMR (or even what the means really). I basically asked him to make sure that the timing, knock retard, air/fuel...
Yes, I also have the Diablo. I guess I was thinking it should have been about 390, but I could be just dreaming! So I guess the next...
Yeah, I saw your ride! That new diff look sweet! You will have to report on how it performs. When I left at about 11:30 this morning, I think...
Can't wait to see what my beast puts down on RWHP and Torque? Going to have him check a few things too, timing, knock, etc. I will post up...
X2 I purchased Bendix for the front and rear because I too needed pads quickly, and the do squeak at low speeds. Seems like the do not sqeak as...
Cool! Thank you for the info! This is kind of what I was thinking. I will not be going this Saturday, so it may be next Saturday, March 21....
If you have been to the Sacramento Raceway, what is a better time to go, Saturday Test and Tune, or Wednesday Night Drags? I was thinking...
Thank you to those who've provided some feedback thus far! Anyone else care to chime in as well??
Preference between the two? And why? :grin:
I would like to get my Magnum on a dyno in the up coming couple of weeks. What are some shops between Bakersfield and Sacramento that would be...
Sorry, no. I don't have it yet. It was taking to long where I ordered it from so canceled. I am hoping to secure one in the near future,...
It's ok! greatone61 understands. :grin:
