Gonna try this on our new Dyno and see how it works. Seems like an easier idea than puling the driveshaft. Is there any difference to pulling the...
1/4 mile time: 12.64 Trap Speed: 106.6 Weight of vehicle with driver (pounds): 5080 Horsepower @ flywheel = 488.73 HP Those are some...
The wire the "2wd mode" switch was wired in, it just stops the enagagement actuator motor in any position. Sometimes, it can leave the transfer...
Apparently driving these things in 2wd mode does bad things to the transfer case. Lesson learned. At least I know how to rebuild them now, hehe.;)
Fixed. 4 of 7 clutches were toast. Put new clutches and steels, cleaned everything up and she runs like dog on fire.
Well, it looks like the GC was run in 2wd mode too long and burnt up the clutches in the transfer case. New ones are ordered and will be here next...
Tested the actuator for the transfer case, it gets voltage properly, but doesn't move or make any noise. I think it burnt out, so I'll drop in a...
Drain the TC fluid last night, it was black and smelt of burnt clutch material. I will probably drop it, crack it open and see if there is any...
Thanks guys! Tried another scan tool on it and can't find codes with either. I'm thinking there may be an issue with the TCM. Truck has 52k miles...
I've got a 07 SRT8/GC that threw the "Service 4WD system" on the the dash. The truck is now in RWD only, so I figure it is a transfer case...
Separate names with a comma.
