What did I break? Anyone???

Almost sounds like you blew a syncro.

With the car running on a flat surface, in neutral with the clutch out. Gently try and push it into gear, don't put it in gear just push up against the gate. If you feel the car starting to try and move forward you are good. If it grinds or makes a horrible sound then you probably blew a syncro or jacked up one of the forks.

 

sounds like your slave cly or master went out

 

yep but u should be able to get it in 2 and 4 also the rpm needs to be real close and ease it into gear or your pivot fork is done what u need to do is there is a cover near the slave its about 3" wide and 1" tall and its black and plastic and look inside and have someone push in the clutch and see what happens

 

yea its right near the slave cly get a flashlight to look and it will be easer to do it from the bottom of the car also

 

sounds like the slave like goat said. is ur peddle adjusted all the way out.....ur shts broke haha.

 

it might be a little bit moor than a master or slave.. if 2 and 4 are on the same spline it may be a sync..... I hope that it's a master or slave a lot less money.....

 

check the bushing that connects the pedal to the slave cyl. its up under the dash where the linkage goes through the firewall. i think i've broken 3 of those now.

 

yah after thinking about it. it doesnt sound like the slave or master because the clutch would most likely be sitting on the floor if it were one of those.

 

it could be that you bent the clutch fork.

 

did you check the line from the slave to the tranny? is it leaking anywhere? its possible you broke the throw out fork.