Official Tampa Bay and it's neighbors trend

Discussion in 'SouthEast' started by zaksblaklabel, Dec 4, 2007.

Thread Status:
Not open for further replies.
  1. packerfan43042

    packerfan43042 Full Access Member

    Messages:
    160
    Likes Received:
    0
    Joined:
    Dec 8, 2007
    Location:
    TaMpA
    Thanks for cleaning up the mess Jesus. Car feels a lot smoother now but still running lean. Still confused lol.

    Juan, thanks for the info. Gonna test mine out again sometime this week.
     
  2. KrazyRdR83

    KrazyRdR83 Dig or Roll?

    Messages:
    918
    Likes Received:
    0
    Joined:
    Dec 4, 2007
    Location:
    Fort Riley, KS
    no prob bro...good luck with the tuning...i'm trying to get my setup on point too lol
     
  3. Cygnus

    Cygnus Platinum Supporting Member

    Messages:
    4,679
    Likes Received:
    0
    Joined:
    Dec 4, 2007
    Location:
    St. Pete, FL
    No problem! If I were you I would check on that dp gasket. I didn't realize mine was bad and that could be the reason of my false afr readings showing in the 11.3-11.6 untuned. That's isn't lean but its still not where it should be.

    If the dp gasket is fine, do a boost leak test... if all is fine, swap out injectors and try to tune for them if not get a canned tune.
     
  4. Indian srt-4

    Indian srt-4 Mr. Warranty

    Messages:
    156
    Likes Received:
    0
    Joined:
    Dec 6, 2007
    Location:
    Tampa/Gainesville
    thanks, i talked to the guys on the OTHER site and they said that i might have had false knock because i was short shifting, and the car spiked 19psi. my god my car never pulled that hard!!!. i going to play around with it some more when i get a wideband. for the most part my car had zero knock and and in certain spots i had 2.5 to 3 counts of knock.
     
  5. KrazyRdR83

    KrazyRdR83 Dig or Roll?

    Messages:
    918
    Likes Received:
    0
    Joined:
    Dec 4, 2007
    Location:
    Fort Riley, KS
    i'll be ordering a wideband here soon, a b-day gift to myself lol. but i have it down to 1 count of knock...and only happens in 3rd gear at around 5600 (where timing peaks to 27 degrees and then settles down to 23), 4th gear is fine, and timing is 21-22 degrees in that gear.
     
  6. Goats

    Goats God of skittles

    Messages:
    2,482
    Likes Received:
    0
    Joined:
    Nov 6, 2007
    Location:
    sOuTh FlOrIdA
    they all knock there for some reason
     
  7. KrazyRdR83

    KrazyRdR83 Dig or Roll?

    Messages:
    918
    Likes Received:
    0
    Joined:
    Dec 4, 2007
    Location:
    Fort Riley, KS
    really...hmmm, wish there was a way to get that timing down in third lol
     
  8. KrazyRdR83

    KrazyRdR83 Dig or Roll?

    Messages:
    918
    Likes Received:
    0
    Joined:
    Dec 4, 2007
    Location:
    Fort Riley, KS
    snap...new years eve...almost 09 guys and gals
     
  9. packerfan43042

    packerfan43042 Full Access Member

    Messages:
    160
    Likes Received:
    0
    Joined:
    Dec 8, 2007
    Location:
    TaMpA
    Like 15 more hours lol
     
  10. Cygnus

    Cygnus Platinum Supporting Member

    Messages:
    4,679
    Likes Received:
    0
    Joined:
    Dec 4, 2007
    Location:
    St. Pete, FL
    08 will be over soon. Wish everyone the best into 2009 and hope the year goes well for everyone!!!
     
  11. packerfan43042

    packerfan43042 Full Access Member

    Messages:
    160
    Likes Received:
    0
    Joined:
    Dec 8, 2007
    Location:
    TaMpA
    Hope this will be the year my car will be working 100% lol
     
  12. Cygnus

    Cygnus Platinum Supporting Member

    Messages:
    4,679
    Likes Received:
    0
    Joined:
    Dec 4, 2007
    Location:
    St. Pete, FL
    Hope in 2009 I can mod the car again without having to part it out at the end of the year :pirate:
     
  13. Cygnus

    Cygnus Platinum Supporting Member

    Messages:
    4,679
    Likes Received:
    0
    Joined:
    Dec 4, 2007
    Location:
    St. Pete, FL
    Anyone out there? HEEEEEEEEEEEEEEELLLLLLLLLLLLLLOOOOOOOOOOOOOOOOO!
     
  14. KrazyRdR83

    KrazyRdR83 Dig or Roll?

    Messages:
    918
    Likes Received:
    0
    Joined:
    Dec 4, 2007
    Location:
    Fort Riley, KS
    ya....lol, just got home from work. i'm beat
     
  15. Vipz

    Vipz Attack the 'Ring

    Messages:
    500
    Likes Received:
    0
    Joined:
    Dec 4, 2007
    Location:
    Tampa, FL
    now that the semester has started back up, I'm drowning in work
     
  16. KrazyRdR83

    KrazyRdR83 Dig or Roll?

    Messages:
    918
    Likes Received:
    0
    Joined:
    Dec 4, 2007
    Location:
    Fort Riley, KS
    prob going to the track tonight...see how things go
     
  17. Cygnus

    Cygnus Platinum Supporting Member

    Messages:
    4,679
    Likes Received:
    0
    Joined:
    Dec 4, 2007
    Location:
    St. Pete, FL
    Bryan, that's why you don't slam classes when you work. I've done it and I was working full time and doing school full time. I know the feeling and I cut back on the amount of classes per semester.

    Good luck Juan! Let us know how it goes.

    If anyone needs help with anything I've decided to start working on these cars again. Just an FYI.
     
    Last edited: Jan 7, 2009
  18. cherbear

    cherbear Supporting Member

    Messages:
    11,542
    Likes Received:
    0
    Joined:
    Dec 5, 2007
    Location:
    St. Petersburg, FL
    yup been there done that one also before. I did school in the am till about 12, then straight to job #1 until about 6 than to job #2 till midnight.
     
  19. packerfan43042

    packerfan43042 Full Access Member

    Messages:
    160
    Likes Received:
    0
    Joined:
    Dec 8, 2007
    Location:
    TaMpA
    That was me monday. School 8am to 4. Work 5-11:30. Felt like dying.
     
  20. Vipz

    Vipz Attack the 'Ring

    Messages:
    500
    Likes Received:
    0
    Joined:
    Dec 4, 2007
    Location:
    Tampa, FL
    I don't have a choice if I want to graduate. It wasn't something I wanted to do.
     
Thread Status:
Not open for further replies.